1. 橡膠接頭

        JBQ氣墊減震器安裝說明

          JBQ 型 空氣 減震器安裝說明

          Q JBQ n Installation n description f of r air k shock absorber

          

        JBQ

         

          安裝前,請確認空氣減震器的型號規格是否正確。

          BBefore installing, please confirm that the size of the shock absorber is correct.

          安裝說明

          Installation guide

          所需工具:公制口徑 19mm (M12)、24mm (M16)、30mm (M20) 開口扳手、打氣筒、壓力表、水平

          尺、爪式千斤頂。

          The tools required are 19mm (M12), 24mm (M16), 30mm (M20) open wrench, air punch,

          pressure gauge, horizontal ruler, and claw jack.

          在沒有任何荷重的情況下,空氣減震器內請勿充氣。

          In the absence of any load, do not inflate in the air shock absorber.

          用爪式千斤頂慢慢將設備頂高至臨時墊木(100~110mm)相同高度。(如圖 2)

          With the claw jack, the height of the device is slowly raised to the same height of

          the 100~110mm. (Fig 2)

          將空氣減震器與設備固定孔固定。(如圖 4)

          Fixed the air shock absorber with the fixed hole of the equipment. (Fig 4)

          充氣時:以空壓機或打氣筒直接充氣至正常使用高度,空氣減震器內氣壓過高時,可以按住氣

          門嘴排氣至正常高度。(如圖 5)

          When inflated: air compressor or inflator can be directly inflated to normal operation

          height. When the air pressure inside the shock absorber is too high, it can hold the

          valve to the normal height. (Fig 5)

          

        JBQ

         

          氣門嘴與常規汽車輪胎氣嘴相同。

          The valve mouth is the same as the conventional car tire.

          最大使用壓力為:4.5kg/cm2=0.44Mpa,但充氣時要與空氣減震器正常高度為調整基準。(高度為 100mm~110mm)

          The maximum use pressure is 4.5kg/cm2=0.44Mpa, but it should be adjusted to the normal height of air

          shock absorber when inflating. (height is 100mm~110mm)

          以水平尺檢查設備的水平度,并以充氣及放氣來調整水平。(如圖 6)

          The level of the equipment is checked with a horizontal ruler, and the level is adjusted by inflating

          and deflating. (Fig 6)

          使用溫度范圍:-10℃~60℃,可以安裝在室外。

          Use the temperature range: -10 C ~60 C, can be installed in the outdoor.

          安裝和使用時,請注意氣門嘴和空氣減震器橡膠處不能受到外界損壞。

          When installing and using, please note that the valve mouth and the rubber of the air shock absorber

          can not be damaged by the outside.

          

        JBQ

         

          保養點檢項目:每月觀察空氣減震器高度是否正常,是否需要充氣維持正常高度。

          Maintenance check items: whether the air shock absorber height is normal

          every month and whether it needs to be inflated to maintain the normal height.

          注意:移動設備前請先按下氣門嘴將空氣減震器氣壓排出,以免造成空氣減震器損壞。

          : Note: e before e the e mobile , device, e please s press e the e valve h mouth t first o to e discharge air

          k shock , pressure, o so s as o to d avoid e damage o to e the r air k shock absorber.

        橡膠接頭減震器金屬軟管空氣彈簧成功案例行業資訊關于我們聯系我們

        Copyright ? 2018 上海松夏減震器有限公司 版權所有 All Rights Reserved.

        香港6合133彩票网站 巧家县| 夹江县| 阆中市| 扎赉特旗| 江都市| 江西省| 铁岭市| 紫金县| 新沂市| 尖扎县| 河源市| 拜城县| 乐都县| 阿克| 渭源县| 如皋市| 公安县| 奉贤区| 辽宁省| 日喀则市| 肥东县| 平昌县| 昆山市| 靖边县| 山东| 且末县| 黄大仙区| 乌鲁木齐县| 定州市| 金昌市| 滦平县| 凉山| 青冈县| 永靖县| 新河县| 郸城县| 甘孜| 大荔县| 咸丰县| 石屏县| 吉木乃县| http://www.lsj279.club http://game.8ud0x1.top http://www.012un.cn http://v.lsjqm5.club http://www.able19g.top http://v.lsj158.pw